Class	Date	Topics Covered	Reading	Course ware	Work due
01 T	Dec. 02	Introduction to System Planning & Design. Review of Power Circuit Theory.		C-01
02 R	04	Introduction to System Planning & Design Continued. Review of Motors.	notes	C-02
03 T	09	Branch and Feeder Design. Example Project Specifications.	notes	C-03
04 R	11	Course Project Specifications. Introduction to PTW Software.	notes	C-04	HW 1
05 T	16	Visit Danisco Plant. (NOTE: actual visit is scheduled for the 12^th).	notes	C-05
06 R	18	Fault Calculations (single-phase & three-phase). Work on the Example Project.	notes	C-06	HW 2
07 T	Jan. 06	Circuit Breaker Sizing. Load Flow Analysis.	notes	C-07
08 R	08	Work on the Example Project. Start Course Project.	notes	C-08	HW 3
09 T	13	Symmetrical Components. Unbalanced Fault Analysis.	notes	C-09
10 R	15	Test 1.		C-10	HW 4
11 T	20	Application of Fuses. Fault Analysis by PTW Software.	notes	C-11
12 R	22	Manual Coordination of Relays. Protection Coordination by PTW Software.	notes	C-12	1^st Proj.
13 T	27	Work on the Example Project (Faults and Protection Coordination).	notes	C-13
14 R	29	Grounding & Ground Faults. Complete the Example Project.	notes	C-14	HW 5
15 T	Feb. 03	Distorted Waveshapes and Power Quality. Harmonics by PTW Software.	notes	C-15	HW 6
16 R	05	Test 2.		C-16	2^nd Proj.
17 T	10	Possible Second Plant Visit.	notes	C-17
18 R	12	Work on Course Project. Tour HMU to see typical building facilities.	notes	C-18	3^rd Proj.
19 T	17	Work on Course Project.	notes	C-19	HW 7
20 R	19	Test 3.		C-20
TOP

---

cliff grigg

Last modified: January 27, 2009