Note to XS-40 Board Users:

 

If your design does not require the microcontroller, be sure to add a port that can be used to hold the microcontroller reset pin high. This will cause all of the microcontroller pins to enter high-impedance mode, thereby effectively removing the microcontroller from the board and freeing microcontroller-connected FPGA pins for other purposes.

 

Similarly, if your design does not require the RAM, be sure to add a port that can be used to hold the RAM output enable pin high. This will cause all of the RAM output pins to enter high-impedance mode, thereby effectively removing the RAM from the board and freeing RAM-connected FPGA pins for other purposes.