EM
104 Graphical Communication
Week
10 - Introduction to AutoCAD
AutoCAD Topics
Hidden
lines
Center
lines
dimensioning, center mark
*****************************************************************
Classwork 10.1 – Using AutoCAD, draw and
dimension the front and right side views of the object shown in Figure 4.85G
#75 on p. 147 of TGC (also attached as Handout CW10.1). Insert a title block and submit a hard copy.
Classwork 10.2 – Using AutoCAD, draw and
dimension the three principal views of the stop base shown in Figure 8.125 on
p. 453 of TGC (Figure 6.111 on p. 376 of FGC).
Make the left-front view of the isometric the profile view in the
orthographic projection (this means that the front view is the left-back of the
isometric view). Insert a title block
and submit a hard copy.
Classwork 10.3 – Using isometric paper,
sketch the isometric view of the object shown in Figure 8.92 #6 on p. 439 of
TGC (Figure 6.95 #6 on p. 360 of FGC).
Use a scale of 1 unit = 3 iso-blocks.
